LGK-120 IGBT Inverter Plasma Cutter
- Detail
- Parameters
LGK-120 IGBT Inverter Plasma Cutter
LGK-120 IGBT Inverter Plasma Cutting Machine Air Plasma Cutter Cut 120
1.It has the arc pressure signal interface connected with the CNC system, and also with the arc successful signal interface
2.Low frequency arc, small arc keep running, greatly reduce interference to CNC system.
3.Soft switch IGBT full bridge inverter technology, double closed-loop current control(UC3846)
4.Machine is with passive power factor correction technology with high power factor and input voltage range from 320v-450v.
5.Constant current output, overcome the voltage drop, it overcomes the cutting instability, arc bias phenomenon caused by different length of plasma arc.
4.High inductance reactor, high arc pressure design, energy concentration, cutting seam narrow.
5.Cutting at least 20A to maximum cutting current continuously adjustable.
6.With non-contact high frequency arc striking method,with the pilot arc function, excellent instantaneous arc strike.
7. Built-in overheating, overcurrent, air undervoltage protection circuit to extend the service life of the cutting nozzle.
8.With 2T/4T selection function, it is convenient for long welding operation, full digital current display.
9.More than 160A models are equipped with water-cooled cutting torchs, which greatly extend the life of accessories.
| Arc Start Non-Contact Arc | |||
| Recommended Air Compressor Displacement m3 | |||
| Dimension(mm) | |||
1. High finish, precision and verticality ------------- avoid or reduce a large number of secondary processing, greatly improving production efficiency!
2. The wearing parts with long life and low cost ----- save the using cost !
3. Only need compressed air and power supply ---------achieve fine cutting of carbon steel.
4. Change the cutting process ------achieve fine cutting of stainless steel, copper, aluminum, and other metal.
YOMI LGK series of fine plasma cutting power sources are good quality products with frontier technology in China and are the high-end equipment that can really match with foreign fine cutting machines in cutting precision, verticality and life of wearing parts. The cost of wearing parts is a fraction of that of a foreign country.